- Keep the marks on in the Films tab
- Measure the 50 mm ruler on the first film
- Stack the films on a light table, marks over marks
- Check that the whole set is there, in order
- Set a trap for what the press cannot hold
What do registration marks do?
They are the same target on every film. Laid on top of each other, the films' marks must coincide; on the press, the screens are adjusted until the printed marks, or the art itself, line up. Shops do it in different ways: printers on TheShirtBoard describe keeping the marks in the same place on every job, and using centre-line marks for one-colour work.
What should every film in a set carry?
- The same marks in the same position, on films of the same size.
- The print order (1/4, 2/4…), so nobody burns or prints them out of sequence.
- The ink, mesh, LPI, angle and dot, so the screen room knows what goes where.
- A ruler of known length, to prove the film printed at 100 %.
- Whether it is mirrored.
Zorofilm's films carry all of these: four ring-and-cross targets in the margin, at the middle of each side, and a label strip with job, place, print order, ink, LPI, angle, dot, mesh, resolution, MIRROR when mirrored, the date and a 50 mm ruler. The margin is 15 mm by default; turn the marks off in the Films tab if your press uses its own system.
How do you check a film set?
- Measure the 50 mm ruler on one film. If it is not 50 mm, the film was scaled: print it again at 100 %, never “fit to page”.
- Stack the films on a light table, marks over marks. They should coincide on every film.
- Check that every film of the set is there, in the numbered order.
- Look for weak or banded blacks. Banding usually means missing nozzles: Help → Nozzle check prints a small pattern on plain paper.
Which way round does the film go?
Sources disagree on which side of the film should face the screen, so follow your emulsion or film maker's own instructions. If you need the image flipped, turn on Mirror in the Films tab: it flips the art, the marks and the label together, and the label says MIRROR.
And on the press?
Marks get the films right; the press still moves. Trapping hides the small gaps that are left. The registration-mark sheet prints marks for setting up a press without a job.
Avoti
- TheShirtBoard, “Film sizing”, 2017 · skatīts 2026-11-04
Iestrēdzis pie kā cita? Jautā — Zorofilm komanda atbild uz katru jautājumu.
Uzdot jautājumuJauni sietspiedes ceļveži tavā e-pastā
Apmēram viens e-pasts mēnesī: jauni ceļveži, risinājumi problēmām, par kurām cilvēki jautā, un Zorofilm jaunumi.
