- Choose your press in Base & trap
- Or measure your press's largest gap and enter twice that
- Check the edges between inks with the loupe
- Measure again when frames, mesh or press change
Why trap at all?
Screens never register perfectly: frames flex, mesh stretches, platens shift. Where two inks only touch, any shift opens a thin line of garment between them. A trap makes them overlap a little, so a small shift stays hidden under the darker ink.
Which ink spreads?
The lighter one, under the darker one, so the darker edge keeps defining the shape; that is general prepress practice. A black keyline that overprints the colours under it hides registration the same way, and Fresener traps a black outline by fattening the black.
How much trap?
- Fresener (T-Biz): 2–4 pixels at 300 dpi, about 0.17–0.34 mm, and more on loose presses.
- Trimingham (Screen Printing, 2025): print a test, measure the largest misregistration gap and trap twice it. His example: a 1/64 in gap gets a 1/32 in trap; specialty items may need 1/16 in or more.
- Heavy white through fine mesh, and underbase screens, stretch more (Trimingham).
- Too much trap causes bleeding, loss of detail and colour shifts (Trimingham). Keep a small trap even on a press that registers well.
What does Zorofilm do?
Base & trap → Press sets the trap: Automatic press 0.1 mm, Manual, tight 0.2 mm, Loose / wooden frames 0.4 mm. These are our starting points drawn from the sources above, not measurements of your press, and the app marks them as estimates; type your own value once you have measured your gap. The lighter inks spread under the darkest one inside the artwork only, never onto the shirt. A one-ink job gets no trap.
How do you find your own gap?
This is Trimingham's method: print a two-colour test without trap, using films with marks, find the worst place between the two inks, and measure the gap there (a loupe with a scale helps). Enter twice that as the trap. Your press, frames and mesh decide the number, so measure again when one of them changes.
Izvori
- S. Fresener, “Choking, Trapping & Cleaning up Type in Photoshop”, T-Biz Network, 2017 · preuzeto 2026-11-01
- T. Trimingham, “How to trap artwork for screen printing”, Screen Printing, 2025 · preuzeto 2026-11-01
Zapeo/la si oko nečeg drugog? Pitaj — Zorofilm tim odgovara na svako pitanje.
Postavi pitanjeNovi vodiči za sitoštampu direktno na tvoj imejl
Otprilike jedan imejl mesečno: novi vodiči, rešenja za probleme o kojima ljudi pitaju i novosti o Zorofilmu.
